« Classic Holmes Disable Windows 7 Thumbnail Caching on Network Locations »
Patrick Stewart On The Internet
Permanent Link
Josh’s Recent Datacad Posts- Datacad Forum Feed
- DataCAD 20 • Re: version upgrade October 15, 2018New license. Only versions 16 and up are eligible for upgrade pricing.Statistics: Posted by joshhuggins — Mon Oct 15, 2018 10:25 amjoshhuggins
- Available to Hire • Drafting help available October 15, 2018I have been designing homes and providing drafting services for 26 years. My fees are based on the project size and scope of work. Let me know if I can assist you with your design/drafting needs.Statistics: Posted by 2mackids — Mon Oct 15, 2018 10:17 am2mackids
- DataCAD 20 • version upgrade October 15, 2018Is going from version 11 license to version 20 considered an upgrade or a whole new license?Statistics: Posted by GARY247 — Mon Oct 15, 2018 8:33 amGARY247
- DDN Discussion • mode_group does not find all entity types (Classic DCAL) October 13, 2018Just noticed that mode_group does not find all entity types. It does not appear to find entities with entity types > 30 (this includes MText, PText and Wall entities etc).Even if you pass an entity of one of these types to the mode_group call, that entity is not found by mode_group (although it will find […]dhs
- Wishlist • Re: DataCAD 20 Wishlist October 12, 2018For drawing a bubble to call out a detail, it can't have the "reverse" on the short side, where the fillets run past each otherok, Neil did find a bug in the beta macro (related to the text scale setting). I have now fixed that and uploaded a new version to the same url (http://www.dhsoftware.com.au/downloads/beta/DHBOX.zip).Rgds […]dhs
- Wishlist • Re: DataCAD 20 Wishlist October 12, 2018It looks like it is either size or percentage? Is that right?That's not quite right Neil. The basic design is either size or percentage, but (in order to accommodate your requirement) if the rectangle is too small for the specified size then it will revert to using percentage (even though size is enabled).So, to make […]dhs
- DataCAD 19 • Re: dimension problem October 12, 2018Thanks Roger and Josh, After I posted yesterday, I just got frustrated and shut down for a few hours. When I started up again, the problem was gone. ?????Thanks for your help.BobStatistics: Posted by Bob Urbanek — Fri Oct 12, 2018 12:25 pmBob Urbanek
- DataCAD 19 • Re: Rotating attribute October 12, 2018TTFs usually work better for this than the SHX fonts.Statistics: Posted by joshhuggins — Fri Oct 12, 2018 10:36 amjoshhuggins
- DataCAD 19 • Re: Rotating attribute October 12, 2018If you set the text alignment to be Middle and Center, and when placing the symbol make sure "Fix Text" is on, you should be able to rotate and or Dynamically Flip the symbol any direction.Note, some fonts do this better than others. Font ArchD seems to work for me and my door numbers.Statistics: Posted […]Roger D
- DataCAD 19 • Rotating attribute October 12, 2018I have an attribute symbol that is a circle with a letter or number in it. Is there any way to position the letter or number inside the circle so that it's position stays centered if you rotate the symbol?Statistics: Posted by GARY247 — Fri Oct 12, 2018 9:21 amGARY247
- DataCAD 20 • Re: version upgrade October 15, 2018
